full-duplex operation

full-duplex operation

Англо-русский толковый словарь терминов и сокращений по ВТ, Интернету и программированию. . 1998-2007.

Игры ⚽ Поможем сделать НИР

Смотреть что такое "full-duplex operation" в других словарях:

  • Duplex (telecommunications) — A duplex communication system is a system composed of two connected parties or devices that can communicate with one another in both directions. The term multiplexing is used when describing communication between more than two parties or devices …   Wikipedia

  • Duplex mismatch — In Ethernet, a duplex mismatch is a condition where two connected devices operate in different duplex modes, that is, one operates in half duplex while the other one operates in full duplex. The effect of a duplex mismatch is a network that works …   Wikipedia

  • Crossband operation — Crossband (cross band, cross band) operation is a method of telecommunication in which a radio station receives signals on one frequency and simultaneously transmits on another for the purpose of full duplex communication or signal relay.… …   Wikipedia

  • USB — This article is about the computer bus to connect peripherals. For other uses of USB, see USB (disambiguation). Universal Serial Bus Original logo Type Computer Hardware Bus …   Wikipedia

  • Modem — For other uses, see Modem (disambiguation). A modem (modulator demodulator) is a device that modulates an analog carrier signal to encode digital information, and also demodulates such a carrier signal to decode the transmitted information. The… …   Wikipedia

  • Push to talk — (PTT), also known as Press to Transmit , is a method of conversing on half duplex communication lines, including two way radio, using a momentary button to switch from voice reception mode to transmit mode.Conventional two way radiosFor… …   Wikipedia

  • Ethernet flow control — WireShark screenshot of an ethernet Pause frame Ethernet flow control is a mechanism for temporarily stopping the transmission of data on Ethernet family computer networks. Contents 1 …   Wikipedia

  • Lynx (protocol) — Lynx is a windowed batch data transmission protocol which utilizes proven techniques of efficiency, reliability and flexibility. It was developed by Matthew Thomas in 1989.* Run length encoding data compression on a block by block basis * 32 bit… …   Wikipedia

  • Universal asynchronous receiver/transmitter — A universal asynchronous receiver/transmitter (usually abbreviated UART and pronEng|ˈjuːɑrt) is a type of asynchronous receiver/transmitter , a piece of computer hardware that translates data between parallel and serial forms. UARTs are commonly… …   Wikipedia

  • Binary Synchronous Communications — Binary Synchronous Communication (BSC or Bisync) is an IBM link protocol, announced in 1967 after the introduction of System/360. It replaced the synchronous transmit receive (STR) protocol used with second generation computers. The intent was… …   Wikipedia

  • Basic rate interface — (BRI, 2B+D, 2B1D) is an Integrated Services Digital Network (ISDN) configuration defined in the physical layer standard I.430 produced by the ITU. This configuration consists of two 64 kbit/s bearer channels (B channels) and one 16 kbit/s data… …   Wikipedia


Поделиться ссылкой на выделенное

Прямая ссылка:
Нажмите правой клавишей мыши и выберите «Копировать ссылку»